Discussion Locked

NIC not recognized

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have tried to install a network starter kit in my 2 PCs, but the NIC is not being recognized in my older machine.

Celeron 300
MB - FIC VL-603 ver 1.2 - 2 PCI slots
Award BIOS PCI/PNP 686
Win 98se

The card works fine as I tested it in the new pc, and the PCI slots in the old pc both work as I tried both of them with my SB Live card. I have flashed the bios with a file fixing a PCI problem but with no luck.

The card is a FA311 Fast Ethernet PCI card by Netgear, model SB105. I have tried PNP detection and manual installation but the card is never detected. I also tried the diagnostics program that came with it in DOS, but this also fails to detect the card.

I have formated the hard drive and clean installed win 98se with the NIC as the only PCI card on the MB and still to no avail.

Can anyone offer any suggestions for this problem - Many Thanks in advance if anyone has some answers.

3 replies

by leea

My first question is, did you try another PCI slot or did you use the same one? If you did not try a second slot try that first. If you have tried the slot, I would sugest trying a new card because he card could be bad.

by thedrummer2006

It sounds like you have a configuration problem. I have seen this problem on many computers before especially older machines.
Plug and PRAY is not all that it says it is.
You have probably got an IRQ conflict or an I/O problem. First check your BIOS to see that Plug and Play is enabled. Next if WIN98SE doenst find it your going to have to tell it the card is there. Just because it doesnt find it on its own doesnt mean that its not working. Your card should have came with a driver disk. Goto your windows Control Panel and goto Add New Hardware. Go through the screens but dont run an automatic detection. Manually tell it what kind of card it is. Then click on Have Disk. Then goto your floppy and find the driver. Then see if windows detects it.
If it still doesnt find it try going into your BIOS and manually setting the IRQ and I/O Address for the slot that the card is in and manually set the card to a specific IRQ.
This can be a pain in the neck but you will eventually get it.Best of luck,
Chris E.

by tkb

Thanks for your help so far - I have tried manually installing the card in windows using the driver disk, but it's still not detected. In my BIOS setup there is an option for assigning either 'PCI/ISA PnP' or 'Legacy ISA' to a specific IRQ or DMA, but no options for specific slots.

Any further ideas....?

This discussion is closed to new replies.