Discussion Locked

NO boot up on new cpu n motherbd P4

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I installed a p4 cpu and abit mother bd S71. when I turn on i get no boot up. no beep codes and mother bd componits dont get warm. Tried another ps ssame problem,, On Intel chip it hsa 1.6g then 266/400 v 1.75 thanks all

8 replies

by thechas

Make sure that the CMOS reset jumper is set to normal.

Many motherboards ship with the jumper set to clear, and that will cause a no boot situation.

If the CMOS jumper is in the normal position, it wouldn't hurt to perform a reset.

Next, double check that the CPU, RAM and video card are properly seated in their sockets.

Make sure that you have the power supply and power switch lines properly connected.

You do have a power supply with the extra "auxiliary" power connector for a P4 system?

Also, try a different CPU fan. Some motherboards will not start up if the CPU fan does not report it's RPM.

The next thing to check is that the motherboard is not shorting out to the chassis.
Either at the mounting posts, or from a long lead.

I have also seen problems if a grounding finger from the I/O shield gets into a connector.

Chas

by csmith

After you have checked the setup, looked for shorts, etc. , which I am sure you have done four times now,
Check the switch.
To troubleshoot/check:
Remove the the small two pin plug that goes from the motherboard to the switch.
Take a very small screwdriver, (Normally called a tweaker) and short the two pins on the motherboard to simulate pressing the switch.
(You just have to touch the screwdriver between the two pins for a second.)
If the PC starts, the switch is bad, or the wire to it.
Regards, Chris

This discussion is closed to new replies.