Discussion Locked

NO Dial tone when connecting to INternet

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I Had been connecting fine to the internet and then after 1 week i got a message saying couldn't connect no dial tone then i took modem out put it back and it worked fine i didn't get that message for another 3 weeks i then replace the 12 ft phone line with 2 6 ft lines connected by a coupler and then i got the message after 5 days was wondering if i needed a new modem or try a brand new phone line thanks for any help you can give me

4 replies

by hal 9000

It sounds more like the Jack or socket that you are plugging into for the phone line being bad. These particularly the RJ12 type can and do go bad from time to time and need replacing. As you have already changed the lead and it works if only for a time I would first be looking at the actual connector that you are plugging into as a possible problem area.

If it's an RJ12 type and has had a lot of different lines plugged into it it could be worn out and need replacing. You also could have a problem with a Line Splitter if you are using one as well or in extreme cases Rf from Wireless phones and the like can cause the same problem.

Col

by nz_justice

Get your phone service provider to do a line test (this service should be free), If your line is sweet, then your problem could be the modem.

If you the line you have is not dedicated to the dialup internet, this can create problems, Alarm and other phone services' can disable the dial tone now and then. eg callwaiting, phone message servce etc...

Your ISP also might be at fault but they are going to tell you they got no problem (it's there standard answer).

by wlbowers

Just unplug the line from the modem and plug it into a phone.

Does it work now. Wiggle the line and listen for noise. No noise, then I would change the modem.

Got noise or cannot dial with the phone, get a new line.

Lee

This discussion is closed to new replies.