Question Locked

No Display

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I recently formatted my C drive, after which I had a problem with my display card with the error code 10 saying my card was not connected.
I removed and replaced the card and now I have no display, no boot-up, no lights on keyboard....nothing.
What is the problem and solution ??
Fairly old hardware: G-Force 2 mx400, AMD 700 CPU, 256 RAM.
Help, I'm lost without my PC !!!

9 replies

by gsquared

I have to ask this: Did you turn off the computer before removing the card and replacing it?

Also, is it currently plugged in?

(Sorry, but tech support requests that start out like your question have to have the "step 0 questions" asked.)

by tony hopkinson

pulling the card while it was powered up.

Nooooooooooooooo !

Chance of popping the internal fuse on the power supply and that would be a good result.

by w2ktechman

that response was much like yours.
NOOOOOOOOO!

all too funny though.

by w2ktechman

Ok, what is probably happening now is that your system either is not recognising the current card properly, there are power issues to the slot, or the BIOS needs to be configured.

First, does the MB have a built in video card?
If so, switch your monitor to it. You should receive video to configure the BIOS for the add-in card.
check that the slot is the right slot for the card.
If you have multiple slots for it, try a different slot.
Is this PCIE, AGP, PCI?
Since you mention old HW, I will assume not PCIE.
For AGP, it may be conflicting with a built in card
for PCI, the bridge may have been damaged, but more likely switch to another port.

by apotheon

Not to disparage all the other excellent advice in here, but:

Have you checked to make sure the monitor isn't shot?

by w2ktechman

You just made me feel stupid for a moment.

I never even thought of that (and I even replaced 2 monitors today).

by apotheon

These days, I try really really hard to always think of the dumb-ass, too obvious to notice, absurdly easy to check, simple solutions before spending too much time on the complex stuff most of us techs come up with first. I find I have to make a conscious effort to do it, though. It's just not natural, it seems, to think of the monitor first in a situation like that.

by w2ktechman

my ability to see the common problems.
Oh, well, I guess its back to tech training 101

This discussion is closed to new replies.