10 replies
The first thing to do is to go into the BIOS and "detect" the hard drive(s). Most BIOSes have an "auto-detect" feature that makes it very simple. If the BIOS can't find that the drive is physically there, open the case and make sure the ribbon cabledidn't come loose. If the BIOS does not detect it, AND the cable is fine, you may have a drive that just failed.
If the BIOS DOES detect the presence of a drive, something else apparently deleted the partition(s). There are some third party software programs that could assist you in that regard. But if it was mine, I'd start from scratch, repartition, reformat & reload the OS. (Because once a disk partition gets "wierd", the whole system usually becomes rather unstable. I wouldn't trust it.)
Good luck,
Maxwell
by lakota tech
by rvanpoppelen
by lakota tech
by danpiers
Assuming that the system was working fine before it started this behavior, a harddisk failure is the prime suspect. Open the case and verify that the power and data cables are properly connected to the drive and the motherboard. Next, verify that the jumpers on the drive are set correctly. If the harddisk is the only drive on its channel, then it must be set to MASTER (or SINGLE is the drive is a Western Digital.) If there is another drive or CD-ROM on the same channel, that device mustbe set to SLAVE and the booting harddisk must be the MASTER. When you apply power, listen closely to the drive to make sure that is is spinning up. It should make a sound like a jet engine revving up (just a little quieter.)
If the drive spins, enter the CMOS Setup and have the system auto-recognize the drive. If it does, let it set the parameters. (If it doesn't, the drive has probably failed.) If the parameters set agree with the size of the harddisk, then run FDISK. (If the parameters do not agree with the drive, then you migt need an overlay program such as EZ-BIOS.) If FDISK cannot see the drive, it is probably bad. If FDISK sees the drive, choose the 4th option. If there are partitions shown, see if they agree with the size of the drive. Also, if you see only non-DOS partition(s), then the drive was probably using an overlay such as EZ-BIOS. If there are no partitions set, press ESC and try setting one using the 1st option. If that works, exit FDISK and format the partition and install your Windows. Good luck.
by lakota tech
by grump
Lets use some logic... If the HD is dead the nothing form above is going to even get close.. When you power on the PC can you hear the HD spin and the heads seek cylinder zero? If you don't hear the HD spin when you power on the PC more than likely the HD is DEAD.. Replace it and the begin to initalize the new HD..
Simple Deduction.. Good Luck.
by grump
by lakota tech
by lakota tech
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending