Discussion Locked

No Fixed Disks Present

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an enduser with a 40G fujitsu drive which
has 2 partitions. The enduser started getting boot sector error messages but decided to ignore them. The operating system is no longer being detected and when booting from a windows 98 boot disk the following error is reported:
"Windows 98 has detected that drive C does not contain a valid FAT or FAT32 partition."
We tried running FDISK however we received the following message:
"No Fixed Disks Present"
We also tried GDISK but it also gives us an invalid error. We tried partition magic but it also gives us an error. We verified the jumpers and changed the cables - we tried putting the drive in another system but the same errors occur. When we tried to slave the drive it was not recognized by the system.
Also, when booting from a boot disk we do get to the c: prompt but it looks like there isn't much information left on it and the d: drive is not accessible whatsoever. Does anyone have any ideas as to what else I can do to try and recover the information on this drive???

2 replies

by mcarlso1

I know you said you slaved the drive to another, make sure the primary is jumped to master and not just the manufactured default. You may also try useing cable select on both just incase controler card on the bad drive may be causing issues, Good luck.......

by rincewind

You could try booting from Win98 boot disk. Ensure that you have a boot disk at the same version level as OS on the HDD.

At the A: prompt type FDISK /MBR to re write the main boot record.

If that doesn't work try rewriting the system files. From A:

SYS C:

You may need to download a HDD diagnostic and do a read test across the whole disk. Only do a read/write if you do not mind loosing your data.

Hope it all works out.

This discussion is closed to new replies.