Discussion Locked

No hard drive found

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I had to format my c: drive because of the Nimda virus infection. After I formatted the c: drive, I installed a CD-ROM drive on the computer. Now when I try to boot from a win98 boot disk, the PC can't find the hard drive and I see a message while booting that there is a boot sector virus. Is there any hope for this machine?

15 replies

by thechas

Start by going to Symantec's or Mcafee's web site and looking at the suggestions for removing the Nimda virus.

If this is a boot sector virus, just formating the drive will not eliminate it.

You can try running fdisk with the mbr switch.
(fdisk /mbr) from a boot floppy.
(Make sure the write protect tab is set on the floppy.)

I myself would then use fdisk to delete the partitions from the drive, re-boot, and re-partition the drive.

Make sure that the jumpers are set properly on thedrive.
Single,
Master w/slave
Slave

Chas

by dmiles

Check the symantec web site for method to delete the Nimda boot sector virus

If you have the hard drive and cd-rom connected to Primary controller,make sure the jumper settings on hard drive is set to Master and CD-ROM set to slave or just connect the CD-Rom to the Secondary controller

Use a clean boot disk and start computer

Choose to boot computer without cd-rom support

At command prompt,type FDISK /mbr
Return to command prompt,type fdisk /u,using this command switch should wipe out all data on drive.

Now use Fdisk to partition and format the drive.

by dmiles

Also you may want to check the BIOS setup configuration to make sure that the drive is being detected

by ddavis

When I run fdisk, it says no fixed disk found. Also, if I try to boot from the win98 boot disk, I get the message c: drive does not contain a valid FAT or FAT32 partition. How can I fix this?

by bohicam1

Was this puter loaded with winnt or win2k? Was it formatted with NTFS? Perhaps that is why win98 boot disk won't see it!
My best advice for eliminating the MBR is to go to google and do a search for a utioity called clearhdd. You can find it on most hard drive manufacturers websites. Run that and it will leave the drive as clean as it left the factory. You may then run fdisk and format the drive.
Good luck!

Mike

by otl

You did not mention the type/age of the computer.

1. Bios could be set wrong for the HD/CD Rom, could also be set to autodetect and drive is not autodetectable (very old). Check jumpers on HD and CD Rom and which IDE/connector they are on. Having both set to master/single drive will "CONFUSE" the computer about what is installed on each cable, making one accessable and the other just eating power. Or if your system supports it cable select setting on both drives (usually jumpered 1 & 2).
2. Power supply may not be adequate for the additional load or just enough to drop output below HD acceptable levels. Unplug the power and ribbon cable from the CD Rom, try fdisk from A: if it works buy heavier duty power supply.

by gigelul

After fdisk/mbr power off computer because the virus can be in memory and infect again HDD or floppy disk. Be sure that you have a clean diskette. Make a new one on other clean computer.

This discussion is closed to new replies.