Discussion Locked

no harddrive,no floppy

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
computer running win 95, it runs through POST and does not detect the hard drive. I tried to boot with a floppy and that was not detected either. Put in a spare drive with the old cables and the computer booted, but the floppy still did not work. Had the hard drive tested and only half of the drive was found. What am I dealing with here?

5 replies

by paul d. masley

A little more information on the system would help, but, First, make sure that the harddrive is set for master and is on the primary IDE, then check the floppy and make sure that it is on a twisted cable and that the twist is next to the floppy and not the board. Then go into the bios and make sure that the bios knows that the hard drive is there. You will have to either set the bios to autofind the harddrive or manually set it. The settings should be on the drive. Also, make sure that you set the floppy to 1.44 in the bios settings. Shut down and boot the system. You should hear a search for the floppy, then the hardrive spin up. This should get you going. If the floppy fails, either the floppy is bad or the controller and/or cardis going south. If the floppy works, shutdown and boot using a WIN98 Boot Disk. Run FDISK, but do not enable large drive support unless you are sure that you have WIN95B or later. WIN95A (16bit mode)does not support large drives(32bit mode). UseFDISK to check the drive and partitions. If they appear to be okay, then use scandisk to correct any errors. This should solve your problems.

Paul.

by rrenn46

First of all was this system running fine before this happened if so sounds like your battery is going .Go to cmos and see if your settings have changed if they have reset them.If this is a system you built you have to do the same thing .Anytime thesystem cant find the hardware like the hd,or floppy always check your cmos first.If the lite stays on ,on the floppy your cable is backwards.and if your cmos settings are ok and it cant find the hd and its a new install check your master slave jumper.If the hd was working and now it doesnt then it maybe bad run fdisk .I hope this helps

This discussion is closed to new replies.