Discussion Locked

no partition on screen

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hard Drive Failure
RUNNING WINDOWS 95a on 1.7g ibm drive spin up and run.
I checked the BIOS information and it checked all right.
I booting the PC to C: NO C: THEN I BOOT w/ DISK to a: TYPE C:\DIR I get no partition. I use fdisk to see, I get no partition on screen.
I can get a no partition
The PC has important Documents on it.

Can you recommend steps at this point, Software or
Technique to bring this drive backup. Please be specific.

If I do this, create a partition will my data be OK. will it delele my data. I'am go home today for the weekend can you e-mail at ffontan1@oncorgroup.com and ffbb@earthlink.net

3 replies

by pgcarter

Ok, first thin make sure the data cable is seated at both ends(it spins so we know it gets power). Next use autodetect in bios so that its not using old info, ie. reporting the drive correctly because it used to see it, but doesn't any more. You might also try slaving it on another machine to get the data off. If these don't help, you can check a document available here at tech rep. entitled "200 ways to revive a dead hard drive". Some of the soloutions in that doc are radical do or die soloutions so you might try some data recovery software (expensive) or even a data recovery specialist, it depends on just how important the data is to you, you're call.
Hope this helps

This discussion is closed to new replies.