Discussion Locked

No power whatsoever...

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I've got a PII400 that was running fine. I usually leave my computer running 24/7 with shutdowns every now and then. I recently installed Win2K Advanced Server on it and then a few weeks later noticed the system was shutoff.

I hit the power button and nothing happened. After removing the power supply, I noticed there was a transcender broken off inside so I replaced it. Still no power. I then replaced the systemboard but kept my old drives, cards, memory, and CPU. Still no power. I then replaced the tower (I thought it might be the power switch) and all of the IDE cables. Still nothing, so I tried to start it up with only the mouse, keyboard, and video card, and still nothing.

Here's the wierd thing. I put the processor in myother computer and the system booted fine but it kept stopping at the memory check during POST only recognizing 1024K of memory even when I had cleared the CMOS. When I put the other processor from the machine that was working fine on the new motherboard, I still got no power.

If it isn't the power supply, IDE cables, motherboard, or expansion cards, what could it be?

Memory? HDD? CPU? ...

8 replies

by ajdelo

Nope. I tried the power cord also. And a different outlet on the surge protector. Neither worked.

by jctech

There are a couple of possibilities here. First of all, a piece of a broken transistor rattling around inside the power supply indicates that the power supply took a surge of some kind, either from an external source (power line surge), or from an overload due to a short in some component that the power supply feeds within the computer. In either case, the supply could have generated an instaneous surge during failure which could have damaged other components within the system, i.e. motherboard, memory, and cpu are primary suspects since they are ultra sensitive to surges. I would start with replacing all three with known good items, leave all the cards out except the video card, and leave power cables to all drives disconnected. Then test to see if it will perform POST. If successful, reconnect drives one at a time and test each step to see if any of the drives are bad. If POST is still not successful, then the video card is shot also.

by jimjennings

If your power supply and motherboard are connected, even if nothing else is connected, you should get power. With the ATX form factor there is a jumper type connection on the motherboard that allows control of the power supply. try finding this and replace it (with power cord disconnected) with a jumper. As soon as you plug the power cord back in it should power up (though it may not start up).

This discussion is closed to new replies.