Question Locked

No sound in windows after using MPEG streamclip

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have been using MPEG streamclip to edit my videos without any problem. However, the first time I used the "delete audio track", I realised that all the sounds in my computer are now gone. There is no sound when I boot up nor when I play anything from internet or windows media player.

I think it could be the sound driver is corrupted but I do not have the sound driver to reinstall. Please advise what I should do.

7 replies

by oh smeg

And checking that the Default Audio Device has not been changed.

Failing that try Rolling Back to a Restore Point prior to you using the Editing Software.

Col

by acforfamily

Thanks for your reply. I have checked that the audio device is correct.
I finally got it working again as I found my installation CD and updated the sound driver. Now I can hear all sounds.
However, now my microphone does not seem to work. i tried changing the sound recording device to either both "hd audio rear input" or "hd audio front mic" but both does not work.

by oh smeg

You'll need to open the Sound Settings and check that. While you are the make sure that the Mic is Boasted as well.

Col

by purpleskys

have you got the jacks plugged in the right holes? (don't laugh, i've seen it happen a number of times)...is there an on/off switch on the cord for the mic (there is on mine). also check the settings within whatever program you are using the mic in.

by acforfamily

looks like the sound problem has not been fully resolved. What I had done after encountering the no sound problem after using MPEG "delete audio track"
1) under control panel - roll back driver but message indicated that there was no roll back available
2) under control panel - sound device - hardware - update driver. I did this using the CD that came with my computer
3) after that, the sound came on. But everytime I logged on, there is an error message - "wrong driver version", " cannot find via hd codec"
4) microphone was working perfectly well when I had the 'no sound' problem. Now that I fixed the 'no sound' problem, mic is not working even though I did not unplug or change anything to my mic
5) tried plug, unplug, mic sound setting changed to mic or front input, replugged jet checked volume control (no mute button) - all does not seem to work

by purpleskys

the computer manufacturers website and see if they have the drivers there...

This discussion is closed to new replies.