Discussion Locked
0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Here is a question for all the hardware guru's. Before I ask thequestion let me tell you what I have done. I have replaced the RAM, CPU, Motherboard, switched from a AGP to a PCI video card, switched power supplies, and have reloaded Windows 2000 and XP multiple times. Okay now for what's happening. When I boot the computer the screen goes blank after the now starting Windows 2000 (or XP). The OS continues to load in the backgroup, but with no video. Does anyone have any suggestions.
6 replies
by d_v ant
Boot into safe mode and change the graphics resolution to 640 by 480 and the refresh rate to 60 Hz. Chances are, Windows is defaulting to a resolution and or refresh rate not supported by your monitor. I have several older 15" monitors with this problem. Once you have video, you can experiment and see which reslolutions and refresh rates work.
by keith g
Neither XP or 2000 will boot into safe mode. The same things happens with any boot option.
by keith g
Neither XP or 2000 will boot into safe mode. The same things happens with any boot option.
by thechas
I agree with D V Ant's synopsis.
I had a similar problem with XP and my bench monitor.
As you have, I could not get into any mode that would allow me to set the display properties so that the monitor would function.
If I connected a different monitor, and finished setup, I could then use the older monitor.
I finally picked up a newer monitor to use on my bench, and have not had any problems since.
As best I could figure, the monitor that I was using did not support the default refresh rate that XP set.
Chas
by keith g
It seemed to be the default refresh rate of XP. I the box on a different monitor and it worked fine. My only concern is that the monitor I was using was a 15" Viewsonic LCD and shouldn't have that refresh problem. Now when I boot I don't see get anyvideo until the Windows logo screen appears. I don't see the loading bar at the bottom that says press F8. It is a minor issue, but annoying. Thanks for the help
by keith g
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies