Discussion Locked

not access to window or MS DOS

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello!
After apply some changes with magic partition software and restart. My laptop has a black screen with a flashing cursor at the left hand side of the screen.
You can acces BIOS but nothing else, not windows not MS DOS.
I try to reboot the system with a flooppy disk and a CD but it?s not luck.
I also try to updated BIOS but nothing happend.
When this happend the computer was working with the battery.
My laptop was working fine before use this software...
Any ideas?
Please help

5 replies

by opatzg9

Sound like the hard disk is unusable in its current state, go into bios and change the drive boot sequence to use the floppy drive first and use your boot disk. Then you should be able to run back through and fdisk or use partition magic to set the drive up.

by otl

In the bios does it show the HD? With the correct specifications (disk size, heads, cylinders)? Was there a possibility that the disk was being used in a compressed mode or a large disk support program (EZ Bios) was being used, this would account for being able to use partition magic and not have it boot afterward, restoring the old settings normally will restore the compressed disk/disk support settings, restoring file access/boot sector information.

Answer # 1 should get you access to theHD, if you can read the files on the HD, check with partition magic/fdisk to verify you have a primary DOS partition and it is the one you want to boot off. If so you can exit and do a sys a:(floppy or ?: CD Rom) c: (primary DOS partition), remove floppy/CD and reboot.

This discussion is closed to new replies.