Discussion Locked

Not Recognizing the Hard Drive

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I had a user who disassembled a workstation and was swapping out hard drives. The system will now no longer recognize the original hard drive for the system and I have tried changing hard drives and have the same results. I am thinking that the BIOSmay be corrupt, when the hard drive is connected it will either lock the system up or go unrecognized. Could there be any other items I am missing? I am trying to find a BIOS but the system is a custom build with one motherboard manufacturer and another manufacturers BIOS. Any ideas?

7 replies

by danpiers

I will assume that the user was swapping the drive to get more space, and not because it was beginning to fail. Almost always, when a system was working, then someone did some kind of maintenance to it, and now it doesn't work...it's usually a loose connection, pulled cable, or something else just as simple.
Make sure that the IDE cable is on correctly at both ends, and the jumpers are set correctly for the present situation. (i.e., if the harddisk is alone on the primary IDE channel, make sure it is set for SINGLE for Western Digital or MASTER/SINGLE for most other drives.) Another thing to check is the cable type. Some cables are for CABLE SELECT only. These will not work properly for drives set to MASTER, SINGLE, or SLAVE. Often,when someone works inside a system, a slight tug at a ribbon cable unseats the connector at the far end. After working on a system, I make it a practice to always, check all connections, check cards for proper seating, check memory seating, look for lost/missing screws, and make sure that nothing is blocking the CPU fan. This practice saves a lot of frustration. Good luck.

by grandhighdruid

It really depends on three things:1)the BIOS, 2)the size of the hard drive, and 3)the cable. 1)check on the web of the manufacturer of the BIOS and the version which comes up on the initial startup screen (you may have to restart the system several times to get all of it, as it doesn;t stay up for very long. 2)there are two known drive limitations; one is the very old one that system that have approximately Pentium 75 or slower processors have a 2.1 GB limitation. There are two solutions to this:1)use the drive overlay software that should come with the drive, or 2)set the hard drive to a drive limitation jumper setting. The other is more recent and perhaps less known. I tried installing an 80GB hard drive into a Pentium 266 machine, and had all sorts of fits getting it to work. The ONLY way I got it to work was to do both of the above solutions for the 2.1GB limitation. Hope this helps.

This discussion is closed to new replies.