Discussion Locked
0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My neighbor brought her (now dust-free) eMachine Celeron 466, Win98, to me yesterday saying the DVD-ROM was not playing her children's game discs (CD-ROM). Inside the drive was a badly scratched, not recognized, PhotoShop disc, I put in a few discs of my own & they were recognized 90% of the time, including a DVD movie, but not music CDs. I swapped out the DVD drive for a CD-RW I have handy, & it wouldn't recognize any discs! I put the DVD back & now IT won't see any discs. The drives were set to Master on IDE-2. When I put a disc in, the green light & the HDD light flash for a (long) while. I don't always hear the drive spin up - the power connector seems a very tight fit - could this be the problem - dicey power? Also, AutoPlay is 'on' but never worked. Thanks.
6 replies
by cg it
dicy data cable more like it or the mainboard IDE connector might have gone bad. I just repaired a Sony VAIO that had a similar problem. Tried the Drive is a know working computer and the drive was ok, changed out data cable and still no good. As ithappend the problem was the mainboard IDE connector. I configured the CD Drive as a slave, connected it as a slave with the Hard drive and the CD drive worked fine. Try the DVD drive in a known good computer and test. If the drive works, swap out the data connector in the eMachine and test. If that doesn't work try the master/slave configuration in the eMachine on another IDE channel. [also, sounds stupid and condescending but verify pin one on the cable is on pin one on the board. sometimes it's a simple as a backwards cable]. Also, check the BIOS during boot up to verify that the BIOS actually "sees" the drive.
by cg it
as a note: kids and computers have a hard time living with each other. Kids have a tendency to not put the CD/DVD in the try right and close the door on the CD/DVD which really chews up a CD/DVD and screws up the Laser head alignment and lens. If that actually has happened it's time for a new DVD player as the drive will just chew up CD/DVDs.
by portnatal
Poster rated this answer
check the data cable if it's fit properly & also check the jumper settings.check the datacable's connection on the motherboard.
sometimes the cd's are not recognised because you have not installed the drivers for the cd of a particular make.once you install those drivers then i guess everything must be fine.
But if it still does not work i think you need to replace the drive.
by portnatal
Poster rated this answer
by portnatal
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies