Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I Have a Dell Insperon 1720 laptop. recently after I wiped the hard drive the screen doesn't get to the max brightness like when its plugged in, effectively making it only useful when plugged in. I have tried the fn + brightness key but it get to a point where I can barely read the screen. i have also played with the power setting for the computer but it didn't help. any ideas?
3 replies
by heikkin Accepted solution
Clarifications
by larryd4 Accepted solution
With in the BIOS settings of the laptop should be controls that limits the brightness of the laptop when plugged in or on AC power. This is the upper limit threshhold of brightness. See if you levels are lower then the max.
by older mycroft Accepted solution
30% of laptop battery power is consumed by the optical drive when in use.
50% of laptop battery power is consumed by the screen when at maximum brightness.
Assuming (after wiping the hard drive) you have a fresh install of your operating system, then the default settings are to chop the brightness when on battery power for obvious reasons.
You'll have to hunt for the power setting governing how the OS reacts when switched over to battery power.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies