Discussion Locked

NT 4.0 Server with Two NIC's Installed

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Recently a built a Compaq Proliant 800 using NT 4.0 server with two NIC's installed. One is the embedded Ethernet and the other is an IBM PCI Token Ring NIC. Each card is connected to different LAN segments with different IP address, but the same subnet and different gateways. The DNS and WINS are the same IP.

The other thing I noticed is with both cards enabled is I can see all my servers using the Newtork Neighborhood and can attach through Server Manager.

The issue I am having is whenI try to ping a DNS alias or an IP address outside of my segment, it times out. When I disable the embedded card, it works.

Any clues?

Regards,
Joe

5 replies

by ksearch

The gateway for each card should point to the other card. And in tcp/ip properties, you must have IP forwarding enabled for each card.
kel.

by tracer_bullet

Have a look at the routing table in the machine. There should be exactly one default gateway (destination 0.0.0.0). Only one Interface can have a default gateway, its the default gateway for the machine, not for the Interface. By giving both NICs a default gatway you confuse the routing table and the machine has no chance to find anything outside your subnet. Put the default gateway in the first NIC (theres a 1 in brackets before its name in TCP/IP Properties). If both Interfaces have a WINS entry make sure the machine gets registered as multihomed or you will have really fun with that one.

This discussion is closed to new replies.