Discussion Locked

NT4 PCI Hayes modem issue

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have difficulty with a PCI Hayes modem on NT4. Installing with the driver cd is fine it detects it and installs it on com 3. RAS installs modem but on the restart it generates an event viewer error. If I start RAS it generates a 633 error. I cannot get phone dialer to work or hyperterminal to connect to the modem. This also is the case on a newly built pc (Compaq Deskpro EXD). Trying to get NT4 to detect and install the modem doesnt work as it doesnt detect it and install it, it only shows com1 and 2.

3 replies

by gigelul

Hi
If you don't use COM1, COM2 disable in BIOS COM1 (or both). If you have a device at COM1 here is an conflict: COM1 and COM3 share the same IRQ3.
If COM2 is available, disable COM2 in BIOS and try to reinstall modem on COM2.

by Former member

I did check all of that, what I did find out from my supplier is that the modem wasnt NT4 compatible after all. I gor a USR internal modem and it went straight in. Florinel thanks for the suggestion

by Former member

This question was closed by the author

This discussion is closed to new replies.