Discussion Locked

NTFS Format

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
If I formatted an HD with NTFS instead of FAT 32 how do I re-format the same HD FAT 32?
Is only DOS 6.0 that allows me to FDISK it again?
Thanks

9 replies

by chocomenta

I do not have any OS in the HDs therefore Partition Magic needs to be installed on another HD. I'd like ideally to make the disk FAT32 for Windows ME or 98SE, but If I format the drives under XP or 2000 (slave of the Prmary HD or Master on Secondary) for some reasons they are then not recognised with FDisk for the full size. No other partitions are active but still 1/2 the size has gone independently of the dimension of the HD (from 320 Mb to 4 Gb)

by chocomenta

Gonna try this tip Thanks

I do not have any OS in the HDs therefore Partition Magic needs to be installed on another HD. I'd like ideally to make the disk FAT32 for Windows ME or 98SE, but If I format the drives under XP or 2000 (slave of the Prmary HD or Master on Secondary) for some reasons they are then not recognised with FDisk for the full size. No other partitions are active but still 1/2 the size has gone independently of the dimension of the HD (from 320 Mb to 4 Gb)

by donmars

What OS are you running? NT 4.0 or 2000? Try Disk Administrator if its 2000 you have then since it supports FAT 32 then Disk Administrator should be all you need to switch back to FAT 32. NT 4.0 does not support FAT 32 so you will have to settle forFAT 16. Disk Administrator is under Administrative tools.

by chocomenta

I tryed your tip but it did not help:(
I'd like ideally to make the disk FAT32 for Windows ME or 98SE, but If I format the drives under XP or 2000 (slave of the Prmary HD or Master on Secondary) for some reasons they are then not recognised with FDisk for the full size. No other partitions are active but still 1/2 the size has gone independently of the dimension of the HD (from 320 Mb to 4 Gb)

by arniej

Get hold of a Windows CD that has either Windows 2K or NT WKSTN or SVR. Go through the setup process until your asked which partition you wish to install the OS on. On the next screne you will be given the following options :

Format partition using NTFS
Format Partition using FAT
Leave the partition as it is

Try selecting the second option displayed above. Once the format is complete, you can abort the setup process. You will then have a disk formatted with the FAT FS

This discussion is closed to new replies.