Discussion Locked

Odd communication cable problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am integrating a digital vison inspection system and need to send RS422 ASCII from an RJ11 plug to a DB9 plug. I have been unable to purchase this cable so I will have to make one, I need to know the proper pin outs for each connector to send a balanced RS422 signal from the RJ11 to the DB9.

5 replies

by rickh9

Check out this link.
http://www.dcbnet.com/datasheet/422conds.html
About the middle of the page it shows you the db9(rs232) to rj45 pinouts. You will notice that only the center 4 pins on the rj45 are used. This is the equivalent of an rj11. IE:3,4,5,6 are the same as 1,2,3,4 on the rj11.
The standard pinout for RS422/485 on a db9 is 2)TX+ 7)TX- 4)RX+ 8)RX- .
So the RJ11 would be 1)RX- 2)TX+ 3)TX- 4)RX+
One cautionary note is that this is NOT a standard since the rj45/rj11 is not part of the EIA spec. so your results may vary.
Good luck.

by estebandelatorre

you will need more than a cable to convert rs422 to rs232, due to the fact that both definitions works with different level voltages and you can damage the rs232 interface
RS422 was defined for long distance cables, thuis it manage higher voltages which you need to convert in order to match the rs232 specifications

This discussion is closed to new replies.