Discussion Locked

On-board video and a video card?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Biostar M6VLQ motherboard, which comes with an on-board Trident Blade 3D video.
When I put my PCI nVidia GeForce 2 MX200 in, the on-board video doesn't display anything and when I plug the monitor into the GeForce all I get are vertical lines.
When I take the card out the on-board video works fine.
I tested the GeForce in a different computer and it works fine.

7 replies

by bigkenny

you will have disable the on board video card in the bios or select the agp port as your default graphics hope this helps

by vas

I checked in the bios, there were options to disable all the on-board devices except the video, and I tried setting the default to the AGP port, but it still did the same.
This motherboard doesn't even have an AGP port, and my GeForce is PCI, but it still has the AGP setting in the bios.

by vas

No, the only setting is where to send the video first, AGP or PCI, when I set it to PCI I get vertical lines, when I set it to AGP the monitor goes into power saver mode.

by oz_media

Have you tried simly disabling the onboard video in the Control Panel under System? That's all I did to get mine working.

by vas

I disabled the on-board video, shut the computer off, put the GeForce in, started it up but it still showed just vertical lines.
I let it boot into windows until it played the logon sound, then I restarted my computer and it worked fine. Thanks.

This discussion is closed to new replies.