Discussion Locked

Operate CD-Rew w/ an added pwr sply

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My computer has a propriatory power supply rated at 140 watts. Iam running 2 hard drives, 1 floopy and 3 cooling fans. I have tried to add a cd-rewriter and the computer would not boot up for lack of power. Can I run the cd-rewriter using an additional power supply and if I can, how would I do it?

11 replies

by dmiles

Even trying to suggest a way to do this is not fesible,and it would probaly cause a problem with the motherboard
Check the motherboard web site to research upgrading the power supply or upgrading your motherboard.
Experimenting with this type of setup,is not possible

by stillatit

Do NOT run anything inside your PC on a separate power supply. You risk your system and your health -- you could easily create a shock hazard.

You CAN buy an external CD writer/rewriter that runs off of a parallel port.

Good luck.

by douglas_debow

at 140 watt's your all ready over by 1 hd and 2 fan's (just an estimate) :)

it is possiable to do but....
you need an electronic varriable power supply (tech-grade)
power supplies from other computer cases tend to fry with out correct load on them.
cheaper to just give up a hard disk ?
get a little extra power that way ?
come to think of it dump a fan to?
why are you using 3 ?

by douglas_debow

if you use a pc power supply. load to the
mother board must be supplied here are the pin out's to make th connection
pin 1 = power good
pin 2 = +5 vdc
pin 3 = +12 vdc
pin 4 = -12 vdc
pin 5,6,7,8 = ground
pin 9 = -5vdc
pin 10,11,12 = +5vdc

by thechas

If your mother board power connectors are standard AT, or ATX, there is an alternate work-around for this problem.

It's a little bit of a kluge, but fabricate a bracket to mount a standard power supply on the outside of your case. Make sure thatthe vent openings on the power supply are clear and will allow air in.
Remove the old power supply, and mount the new supply so that the power cables run through the power connector opening in the chassis.

Cover the vents on the new power supplywith window screen or filter foam to keep small items from getting into the power supply.

You will need to make sure that your computer is vented. Perhaps add an exhaust fan where the old power supply fan exhaust used to be.

If your system uses a propriatory power connector, enlist the help of an electronics technician to rewire the mother board connector to the new power supply.

For a more elegant fix, determine if you can fit the motherboard into a standard case, and do that instead. You can find mini-tower cases with 250 watt power supplies for under $40.

Best wishes.

by thechas

You can also get external drive bays that connect to either the USB or parellel port.

I bought one from TigerDirect for around $40. It has it's own power supply for the drive.

This discussion is closed to new replies.