Discussion Locked

Operating System Not Found

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Computer shut down by itself and when it was rebooted it said operating system not found. Have tried the restore disk and it came up saying that the hard drive could not be found. Checked the settings and all are set to auto. However system still comes up saying hard drive cannot be located. What do I need to do to get it to run

9 replies

by bohicam1

Sounds to me like an older machine. Open up the case and start it up, see if the processor fan is running. If not you may have a fried processor on your hands. Also check the cables to the drive and back to the motherboard. Unplug them and plug themback in then go back into the cmos and redetect them.
Good luck!

Mike

by thechas

From the sound of things, you either have a catastrophic hard drive failure, or you caught a nasty virus.

Watch the screen during the post process.
Is the hard drive located and identified?
If yes, then the drive has lost it's master boot record, or partition table. Either could be the result of a virus.
Personally, I would replace the drive. If it was a virus, it may be hard to remove at this point, and you have already lost all files on the drive.
If it wasn't a virus, the drive is now unreliable.

If no, either the drive, or the drive controller is bad.

Can you borrow another hard drive from a friend?
See if your system recognizes your friends drive.
If not, it's time to buy that new computer, or at least a motherboard and case.

Chas

by yacco

Boot from a floppy with fdisk on it. Run fdisk and see if it can see the drive. If it can, have it display the partition info. If the partition is not intact, try exiting fdisk and at the prompt, type: fdisk /mbr then hit enter. This may restore the master boot record.

by docwhoever

Do more than check to see on the settings if the auto detect on the hard drive is set to LBA. More than once on a older system I have had to reset this setting even when the auto setting is selected. Also see if your cables are secured and the powerplug is secured. You also might want to check your computer's battery and see if it might need to be replaced.

This discussion is closed to new replies.