Discussion Locked

Optical mouse + booting problems

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I installed a MS optical intellimouse on my W98 via USB. Drivers used were the ones that came with the mouse. After restarting the PC following the installation, it hangs on the W98 logo screen. Finally after 4 times of shutdowns, it boots fine.I tried plugging the mouse in a PS2 port(came with adapter) it still did the same thing. Then I replaced my old mouse and the PC did not experience any boot problems. Is there something I'm overlooking or should I use the default drivers?
Thanks in advance.

9 replies

by dmiles

Try enabling the USB port in the bios,the other part is that the drivers newer that what the OS can recognize,therefore it is possibley causing a device conflict,check device manager for any mouse or port conflicts,use the default drivers until you stabalize the installation then update your drivers

by billtcat

I had this same problem with my Logitech USB
optical mouse. I solved it by going into
device manager and removing the USP port and
the mouse then rebooting and letting it find
it fresh. Don't know if there was a conflict
because I just replacedthe PS2 and rebooted.

by mindcrazy

Do you have any other devices with a USB connection installed on your system? If not you may want to find out what chipset is on your motherboard and check the manufacturer website for a patch or updated driver for the USB hub. For example VIA chipset requires a patch after the original motherboard drivers are loaded in order to reconize USB without a problem.

Good Luck

This discussion is closed to new replies.