Question Locked

optical splitter, mux, router for the home theater?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Greets All~

In need of the help from the masses here:

Here is what I'm working on for the home...

multiple rooms;
1-bedroom
2-living room
3-den
4-dining room
5-garage
6-backyard/porch
7-here and
8-there

each location has access to the following on a home made panel:

usb-different types
coax-video
1394
multiple rca jacks
voip
ethernet-catx
optical-audio..like toslink etc...SC connector
hmdi

what I'm looking for is to be able to run video from source X (1-8) to destination Y(1-8) using the same medium at the same time, but the source and destination are not wired directly to each other...kind of like an optical mux, a switch or bridge...but independent of each other too...

Neither the source or destination would be wired together, but to the same device and intelligently routed to the destination.

If you have any idea what I'm trying to do and have any idea...please let me know..thanks in advance!

Bryan

3 replies

by mjd420nova

I've got a similar setup but without the firewire,USB or VOIP. I use a video switch box, actually one for each room to select the coaxial source. I can also do the same for composite video for each room and stereo source. There is a four wire jack RJ-45 and ethernet jack (CAT-5) in each room but it only has one source as I only have one network and one landline. I wish that USB had been available when I wired the house but this was in 1985 and it was just a pipedream then. I could pull more wires now but I'm happy with what I have and I'm not to sure about adding this to my power conduit as it's pretty full now. Remember that each switch and connector you add to each circuit is going to reduce the signal at the other end and might require boosters to give you adequate signal strength and will induce more noise too.

by thechas

For starters, the first places I go when I am looking for networking hardware are L-Com and Black Box.

Both have some fiber switches. I don't know if either fits your needs or budget.

http://www.l-com.com/item.aspx?id=6624

http://www.blackbox.com/Catalog/Detail.aspx?cid=381,1456,1497&mid=1828

The issue with fiber switching is that you are pretty much limited to industrial or commercial equipment.

I'm not sure that I would run USB around the house. For wire runs, it gets pretty difficult to stay under the 5 Meter cable length limit. Even if you installed a repeater at every outlet, that still limits your runs to the hub or device to 5 meters. Or, you need a repeater in every line every 5 meters.

There are long haul USB solutions where you convert to Ethernet or another serial format.

1394 Fire-Wire also has cable length limits. From a quick search, 14' appears to be the "long" standard 1394 cable, with repeater setups required for runs over 32'. One vendor lists 32' 1394-800 cables.

As for the video signal types, both L-Com and Black Box have a variety of different switches and signal splitter options. Of course, that is where it gets expensive. Running from a common central source would be the low cost option. If you need to source from any port to any other port, you could easily have several thousand dollars in switch gear.

Chas

This discussion is closed to new replies.