Discussion Locked

os in a new hard disk

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

help! i am installing a second hard disk into my pc. problem is, there is an os in the drive. how can i disable the os without erasing anything in the second drive???

answer urgently needed

7 replies

by saihib

Is the new hard drive going to be the master or the slave? It doesn't matter if both drives have OS's installed. Your computer will only boot from the master. Don't worry, you won't lose any data.

by dmiles

You donot have to disable the OS

Determine if the new drive will be the Master or Slave,then you will need to set the jumper settings on the drive per settings that are on the top of drive,it will have jumer settings designation for orientation on pins.

Now,boot computer and when startup screen appears,press the key to enter BIOS setup and check to see if the configuration under the hard drive is set to AUTO,exit and save

by tim_vogt

UNPLUG THE OTHER HARD DRIVE THAT IS MASTER DRIVE.PLUG IN THE OTHER DRIVE AS THE MASTER DRIVE AND DO A FDISK AND CLEAN INSATLL. THEN YOU CAN MAKE IT A SLAVE DRIVE AFTER THAT YOU SYS. SHOULD SEE IT WHEN IT REBOOT IT ?

This discussion is closed to new replies.