Discussion Locked

Packard Bell 486DXz 66MHz

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am working on a Packard Bell 486 DXz 66MHz and I replaced the motherboard with a used that I think is good? Now when I turn the computer on it tells me that I have an; "invaild system disk, replace the disk and hit any key". It won't read the CD ROM. I am trying to boot with a WIN98 boot disk. HELP !!!!

9 replies

by nigel100

as far as i know win 98 will not run with 486, try win95 or win3.1.
you may want to check the jumpers on the hd + cd.
how big is the hd (there was a 512mb then 2gb on the older m/boards)
does it boot from floppy? if it does, using the win98 boot the cd may well appear as a different letter (probably o:).
if you need more help i would need to know more about what you had before (assuming it was working) and what you have changed.

by purplebook

Did all the hardware work before you changed out the mainboard?

If so, then it might be the new/old board has a BIOS problem, or the battery is going out, and the list goes on....Not knowing much about Packard Bell 486's, don't know if this helpsmuch.

Why did you change the mainboard in the first place?

by redshift

Check your HDD Jumper settings and position in the IDE chain. Make sure that all cables are snug. Check the BIOS and make sure that it's configured for that particular HDD. Give up, my TI-85's more powerful that that thing!

by the gardener

that disk isnt recognised by the system, yes a 486 is 32 bit machine (likwise 80386 is the first generation 32bit and can handle win 98 (a 32 bit OS)
i use one just for hard drive duplication. slow to boot up but works just fine if you leave it alone.

This discussion is closed to new replies.