Discussion Locked
0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have this pd dirve an the drivers and instructions provided by the panasonic site do not help win98 reconise the device. Mabybe im missig something, can someone thee me how to ger this drive installed and the name of the proper drivers. HELP !!!!!!!!!
7 replies
by faraz67
First check the jumper settings at the backside of your PD/CD it should be on Secondry Master if you are already having two hard drives i-e Primary Master and Primary Slave or you can make your CD/PD Primary Slave in case of only one hard drive. Check the manual completely and then detect your drive bu using Windows ADD/REMOVE Hardware option in the control pannel.
by rusty8195
The PD\CD is a scsi device. Windows 98 identifies the scsi card but can not identify the device. It is the only device on the card and a terminator is in place. Thank you for your efforts.
by ann777
Is it device # 0 in the chain? or is the defauld set to another number?
If win98 recognizes the controller, it should recognize the device. What IRQ is it using? And is Win98 sharing any other devices on that IRQ?
by rusty8195
Poster rated this answer
by csmith
A quick test would be to remove the SCSI card in Device Manager and then click Refresh to see if Windows will properly reload the SCSI card driver.
It should then, on the next boot, recognize the CD drive.
Regards, Chris
by rusty8195
Poster rated this answer
by rusty8195
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies