Discussion Locked

partition failures

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
NT 4.0 primary partition failed. Replaced it, mirrored the contents. Disk 0 was primary, and Disk 1 was mirror. Could not boot unless I used a boot floppy. Ran fdisk /mbr to repair MBR. Upon rebooting from hard drive(successful), Disk 1 is now the primary, and Disk 0 is the mirror. I can't break the mirror, or I lose everything. How can I repair this?

4 replies

by purple713

If you have Windows 2000, install it. I had the same problem with NT 4.0. I installed Windows 2000 and this fixed the problem.

Good Luck.

by tonn

I copied the data from the mirror to the primary, then broke the mirror. After rebooting, I was able to mirror the primary successfully. Fdisk was the culprit.

This discussion is closed to new replies.