Partitioning
I just bought a 100gb hard drive and would like to partition it into 5 seperate 20gb. How do I go about doing this. I've never done this before so a step by step instruction would be great.
Thanks, Troy
Hardware
I just bought a 100gb hard drive and would like to partition it into 5 seperate 20gb. How do I go about doing this. I've never done this before so a step by step instruction would be great.
Thanks, Troy
by fenaikh
Hi
Hard Disk Multiple Partitions:
Create a startup disk and make sure that you have FDISK,FORMAT,sys programs.and put the floppy disk in drive A: and make sure that in BIOS A: is the first drive to boot from.
Run FDISK.EXE: From the command prompt, enter the command "fdisk". Since you have a large disk you will get a warrant to use of FAT32, you will be asked if you want to enable "large disk support". Enter "Y" if you want to enable FAT32, or "N" if you do not want to enable FAT32. If youdo enable this, any partitions over 500 MB that you create will be FAT32.
Select from the FDISK menu "1. Create DOS partition or Logical DOS Drive".
Select "1. Create Primary DOS Partition". FDISK will verify drive integrity. Then it will ask if you want to use the maximum available size of the disk for the primary partition and set it active. Enter "N". The system will show the size of the entire disk in MB.
Enter the size of the primary partition. "20000". The system will tell you that it has created the primary partition, and will assign it the drive letter "C:".
Press {Esc} to return to the FDISK menu.
Select "2. Set active partition". Select partition 1. FDISK will report that it has set partition 1 active.
Press {Esc} to return to the FDISK menu.
Select from the FDISK menu "1. Create DOS partition or Logical DOS Drive".
Select "2. Create Extended DOS Partition".
When prompted, press {Enter} to select the entire remaining area of the disk for the extended DOS partition. FDISK will report that it has created the extended DOS partition.
Press {Esc}. FDISK will automatically prompt you to create your first logical DOS volume within the extended DOS partition.
Enter the size of the first logical partition (the second partition overall). In our example you would enter "800". FDISK will create the partition, label it "D:", and then say "Logical DOS Drive created, drive letters chan
by meanstreet
by ilitho2
by meanstreet
by mrrejohnson
by meanstreet
by meanstreet
This discussion is closed to new replies.
Sort by Trending