Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a machine with an internal Seagate Hornet STT320000A Travan drive that keeps slipping its drive belt. Aside from poor design, I am assuming the problem is a worn/stretched belt. Does anyone know where I might be able to get replacements?
3 replies
by thechas
They will not have the belt listed by what it is used on. However, this site does sell a variety of belts for electronics.
http://www.mcmelectronics.com/Profile/welcome-frame-unregistered.jhtml
I recommend subtracting around 10% from the measured diameter of the belt.
If they do not stock the correct thickness of a square or round belt, use the next larger size.
For flat belts, you need to go smaller instead of bigger, unless there is extra surface on the pullies.
Chas
by rpb
Poster rated this answer
by rpb
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies