Discussion Locked

Patch Panels

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am fairly new to the networking laying cable end of the whole scheme. When punching down to the patch Panel do you make the same terminations at the terminal punchdown jack. In other words the cable should run straight through. Is this the bestway of going about wiring? Someone had also told me about wiring a differnet way, because you can get more speed. What is the best possible way to wire a small office??

12 replies

by dsmacdo

Hi,

Generally speaking, it is standard practice to maintain the same pin to pin punch down between the drop and the patch panel. This however depends on what you will be connecting and there are several standards that apply.

Although you couldvary from this for specific requirements, I would suggest that you do so with your patch cables rather than your horizontal cabling.

Doug

by csmith

The problem with 100Mbs and above wiring is accurately maintaining the twist to prevent reflections.
For in depth coverage, read LAN Wiring by James Trulove. (Should be in the library.)

The old punchdown blocks generate too many reflections at 100Mbs and above.

For a small office we run all of the CAT-5+ cables, unbroken, directly into the hub and do not used punchdown blocks or patch panels at all.

This also produces the best performance.

Regards, Chris

by csmith

,
To add to Ans.#5
A good and simple labeling system is also critical.
Regards, Chris

by chaosad

Well what is your layout for your network?
My self I enjoy the use of switches and active hubs.You can browse the internet to get the A and B standards for your connections. And crossover cables are useing the A and B standard on one line being A on one end and B on the other.You can type network cross over cables on the internet and it will take you to numerouse web sites for patch cables and how they can be implemented.

need more info
over and out chaosad

by dcosgrove

The basic "rule" is to run all the main runs straight through and use cross over patch cables when needed. You will have a much easier time keeping track of things if you do the same thing every time. I'm not sure of "other" ways to increase speed, I've heard lots of tricks but I stick with tried and true, more importantly, reliable.

by rawright

There's several good answers here, but I'll toss in my two cents worth. I went through the same learning process several years ago and learned a few things. First, Cat5 patchpanels are perfectly adequate for 100Mbps signals - you do have to minimize the amount of wire you untwist to minimize crosstalk. The standard allows 3/8" as a maximum. Second, standardize your wiring on the backplane and do any modifications in the patch cables or terminal adapters. If you start mixing connections at the patchpanel, later you'll have a miserable time trying to figure out what you did. When I was first faced with doing this, all of the documentation referenced TIA568A as the preferred wiring standard, yet when I started buying equipment, all of the available products assumed TIA568B - a minor change, but one that can be confusing. Plan from the outset to use the 'B' variant, and wire the patchpanel for straight-thru connections.

Terminate all of your fixed assets (cable segments, routers, hubs, etc) on the patchpanel, then use patchcables to make all of the interconnects. This will allow you to quickly make configuration changes when needed, without the hassle of rewiring anything. And be sure to build in spares - you will eventually need them, and it's cheaper in the long run to plan for them ahead of the need. When a hub fails, you want to be able to quickly move the most critical clients to another working hub while you wait for the replacement to arrive. Good luck - I wish I had it to do over again, as there are many things I'd like to do differently that I've learned along the way.

This discussion is closed to new replies.