Discussion Locked

PC Do nothing

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an Acer 4100 with Celeron, 4Gb HD and 32Mb PC100 DIMM.
I install a PC100 128Mb DIMM and a sec. HD, like the owner's manual saids. When I strat the, the only thing that happens is the CD recognition and then a sound in my HD, then nothing, nill any signal in the monitor.
I put all the PC in his original configuration and the same things occurs.
The components (HD, CD, Floppy and memory) are OK, this because I install in other PC and run, installed with the original cables or with others.
The CMOS battery reports 2.8 Volts, and the voltage of the Power Supp. are in the correct ranges.

The film of dust in the mother is more or less fine.
Please help me, What happens with this!!??

7 replies

by dmiles

The problem seems to be the memory module that you have installed in the system,the module fmay have to be from the same manufacturer for it to work

Check the module and insure that it is seated in the slot properly,then go to the motherboard manufacturers web site and check for memory upgrade to the board

Also when booting computer,at startup screen,press designated key to enter CMOS setup,check to make sure that memory is being recognized,it will have refernce in manual for location

by thechas

I suspect that you loosened some connections by accident when installing your upgrades.

Start by making sure that the original DIMM is properly seated.

Then, check the video card / header.

Make sure the drive cables are seated properly.

Triple check the jumper on the hard drive.
Many require a different setting when used as a single versus a Master with slave present.

I would not be surprised if your new DIMM was incompatible with either your old DIMM or your motherboard.
SDRAMtechnology continues to evolve, and many older systems will not work with the newest DIMMs.

Next, check your power supply.
Many OEM systems do not have enough power supply to handle extra drives and other system devices.
If the power supply is rated at 200 Watts or less, it is likely too small for your present needs.

Chas

by stan

Check the IDE cable on the hard drive. Make sure that the stripe on the cable is connect to pin 1 on the IDE connector on the hard drive and the motherboard. Also check the proccessor and make it is seated properly, then check the connections between the pc case and motherboard and make sure none are loose.

This discussion is closed to new replies.