Discussion Locked

PC does not recognize total RAM

0 helpful
17 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My old (1965) Gateway P5-75 has 64mb RAM installed but on boot up and from every diagnostic tool and system info tool it shows 16mb. I do not know whether this requires a setting change to software or hardware. If software, what do I need to do?If hardware, how do I recognize and adjust the required setting? Gateway support was absolutley useless and actually blew me off with a "you touched the computer, we wont help" response.

17 replies

by guidos

I had a similar problem on my PC at home...what I did was go into the computer setup and change the memory check at startup from quick to full...that fixed it on mine. Hope this helps you.

by rontsc

Setup does not show me a "memory check" item specifying quick or full.
Thanks for trying

by kjnfla

on my gateway 2000 p5-75 i added more ram but it didn't recognize 2 of the modules. what i did was change the slots that i put the memory in ie: larger ram in back and the smaller ones in the front and that straightened out my problem.

by rontsc

All 4 sticks are identical, holding 8 units (2mb ea I assume). 2 sticks are set at 45 degree angle and 2 are set straight at 90 degrees to the board. Swithced them around a few times but didnt help. Thanks for trying.

by vertex

If all this while you are having 64MB and suddenly it downsize to 16MB (hope not due to economic downturn!), this could be due to faulty RAM. Answer 2 suggest changing the slot, this could help. Sometime dust accumalate on the slot connectors, a little clean up won't hurt. However if you just install new sticks of RAM to upgrade yur system, ensure that you have all the same type of RAMs. Don't mix 60 & 70 nanoseconds RAM, silver and gold pins sometime don't get along to well. Run CMOS setup to accept the new RAM value.

by hasse mcse/brainbench

Hi!

Also remember to check if your new and old RAM, if possible, is double sided or single sided SIMMs.

If doublesided, you'll only be able to use two SIMMs allthough your computer has room for four.

If all are single sided, be sure to put the larger ones in first slots, if all are same sices in your bios setting set RAM speed to at least 70 ns, should work even if two are 60 and two are 70, never mix 60 ns and 70 ns beside each other, since they are used in pairs.

Regards
/Hasse

by rontsc

All 4 SIMMs are identical 16 mb single sided sticks which are the original. Something happened when a local tech, since deceased, upgraded my hard drive and installed WIN 95. Everything seemed fine until I upgraded to WIN 98 and now I am slower than molases. Appears to be much swapping going on which I suspect is due to something restricting WINDOWS to 16mb.
Thanks for trying.

by boppinboo

I had a similair problem with a compaq cpu. There was no fix for it because the motherboard was designed to accept only up to 32MB of Ram total. I don't know if gateway designs them that way or not, but I found the answer to my problem on their website.

by pfuller495

This may sound too simple, but could it be "chip creep". Have you checked that each one is sitting in the slots securely?

by ccsbz

If you can get a BIOS Update it is O.K. or you can put thatCow out for dog food.

by gigelul

Try to clean (gentle) memory modules contacts with a rubber. After that don't touch with hand the contacts. Also check the slots contacts for some damage or dirt. I want to remember you that memory modules are sensitive at electrostatic charge.

This discussion is closed to new replies.