Discussion Locked

PC freezes,Scanr not found,unkn USB,

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am still having pc freezes. I am recalling my photosuiteIII and Mirascan software freezing first. So maybe I uninstalled/reinstalled the drivers incorrectly? Then it led to the whole pc freezing I get distorted lines across the screen. Usually butnot always in MS Internet Explorer, shockwave,and in MSAccess. System resources are dropping as low as 4%. I keep getting an unknown device in USB device mngr, fixing it and having same problem again within same session of use. When trying to run MiraScan for the scanner it cannot find it. Could a bad USB port cause all these symptoms? Are all of these situations linked somehow, or am I dealing with accumulated issues?
Before responding, I need to add that I have been troubleshooting this for a while and have tried all the basics, like uninstalling Desktop Themes, and updating MS Internet Explorer *fix, System Tools File checker, clearing temp files and some other little things, so please let me know if my next step needs to be to wipe drive clean and start from fresh. Just concerned it may be a bad driver and that it will begin to have the same problem after reinstalling it. Is this a hardware issue?...the memory card...the video card...the sound card..bad port?

1 reply

by thechas

I agree that it sounds like you have reached the point where a fresh install is what is needed.
It is often very difficult to remove remnants of a bad driver installation.

One final thing to check, is if you are using Windows 9X/Me do you have 511MB or more RAM installed?
These OS's can be unstable with more than 511MB of RAM. So try backing down the amount of RAM.

For your re-install;
Inventory your hardware, and have the latest drivers downloaded.
(For XP, back up your product activation files)
Have just the video card installed in the PC.
Boot from a startup floppy, and use fdisk to remove partitions, and re-partition the drive.
I like to setup a 1.5 - 2 GB partition, and copy the OS files, and driver files onto this partition.
That way, I have everything I need, and never need to swap CD's around during setup.
(I use a hot swap bay on my main PC for this)

Install the OS.
Install the standard VGA driver for the video card at this time.
Install the chipset (motherboard) drivers.
Install DirectX
Install the video card driver.
Shut down, and install your other plug in cards one at a time.
Install OS updates.
Install USB devices.
Install Application Software.

Chas

This discussion is closed to new replies.