Discussion Locked
0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My PC run the POST test alright, but thereafter the display this message " very DMI pool data" and the freezes instead of loading windows files. what should I do? Thanks to all members in the techrepublic site.
7 replies
by oliphant2
HAVE YOU ADDED MEMORY/HARDWARE LATELY? IF YES REMOVE IT AND TRY A RE-BOOT
HAVE YOU CHANGED ANY BIOS SETTINGS? IF YES/NO TRY SETTING THE BIOS TO DEFAULT
IF THIS FAILS RE-SET YOUR MOTHERBOARD USUALLY A JUMPER SETTING ON THE BOARD SEE YOUR MANUAL FOR THIS
The question was auto-closed by TechRepublic
by dmiles
Insert the Windows startup disk and boot computer,at the command prompt type
sys c:
now reboot computer without floppy
Hope this helps
The question was auto-closed by TechRepublic
by lafavor_s
Almost every time that I have run into this one it is because of of the setting in CMOS for EDO ram present. You likely have EDO ram in this machine and if you do not "tell" it that it does, it will stop at the point you describe. The default setting for this choice is no EDO ram present, so either you or someone else, have recently reset your BIOS, or the CMOS battery is dead.
The question was auto-closed by TechRepublic
This question was auto closed due to inactivity
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies