Discussion Locked

PC Just Stops

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an endusers PC that I have replaced the motherboard in. The PC worked just fine last week.
Today the PC will boot up and then once the enduser starts to work, she looses her mouse and keyboard.

I have replaced the video card and it is still freezing when she starts to work. We have to power off the machine to get it to reboot.

What else can I check to see why it is doing this?

12 replies

by rich

This might sound really stupid, but have you tried making sure the mouse and keyboard work in DOS? At least you'll know then whether or not it's a Windows software problem.

Good luck,
Rich

by rich

Oh, yeah -- conflict resolution:

- make sure nothing's using IRQ 12 if you're using PS/2 ports.
- make sure the keyboard / mouse isn't damaged (swap parts)

If you're having trouble with running Windows, try using a serial mouse.

I would pretty much say that it's a motherboard problem if you go through all this. Maybe not, but that's my hunch.

Cheers,
Rich

by redshift

Motherboard replacement is a risky proposition. Re-enumerate all of your hardware by deleting HKEY_CURRENT_CONFIG\Enum (be VERY sure that you make a backup of your registry before doing ANYTHING to your registry) and restarting the PC. This will force it to re-detect every last bit of hardware, forcing out some of the old drivers that may be haunting you.

by redshift

Motherboard replacement is a risky proposition. Re-enumerate all of your hardware by deleting HKEY_CURRENT_CONFIG\Enum (be VERY sure that you make a backup of your registry before doing ANYTHING to your registry) and restarting the PC. This will force it to re-detect every last bit of hardware, forcing out some of the old drivers that may be haunting you.

by vue

I hope you are not running Windows NT Work station. If you do, I would backup all the work station data file and start from scratch. Re-install NT and all the software and then restore the data files. If you are running 95/98, go back to answer #2. Goodluck.

by lafavor_s

If there are socketed chips on the system board, especially cache ram, try reseating them, and reseat all the cards after making sure that they are seated correctly (sometimes cards "work" their way loose, lifting at the front or back of the card). Also check that the CPU fan is running properly, and the heatsink is not full of dust, overheating can cause the CPU to go into thermal overload and "freeze".
***NOTE: do not plug or unplug PS2 devices while the power is on, this will damage the interface(s) on the system board, on an ATX system make sure that power is FULLY off, ie. unplug the power cable. I also don't recommend unplugging AT keyboards on older systems while the power is on.***

This discussion is closed to new replies.