15 replies
by mystic
by ian boothby
by jlouis45
by ian boothby
by bv2
by ian boothby
by robert young
I wholeheartedly concur with my learned colleuges, however it may also be prudent of you to check your jumper settings on the rear of your CD ROM as you may have inadvertently replaced the CD rom to another channel on your IDE cable (IE primary slave etc). Check in the system BIOS and do an auto scan of IDE devices to see if your CD ROM shows up ok. Most modern(ish) machines detect the CD without any problems.
Let me know the outcome.
Regds
by ian boothby
by vue
by ian boothby
by ian boothby
Thanks for all your suggestions - sadly none of them worked, but I now know more.
My single HDD is Primary Master, My CD-ROM drive is Primary Slave.
I note that my HDD is operating in MS-DOS compatability mode.
Drive (CD) IS seen in BIOS (Atapi CD-ROM)(CD-ROM UDMA33), although auto-detect will not list it, only the HDD. Primary slave is set to AUTO under TYPE & MODE.
Drive works perfectly if booted with W98 Startup floppy.
Using this boot mode, I tried to re-install it, but I don't have enough experience on PC's to get the mscdex files up properly, I always get a error "cannot find VFAT drivers".
I did double check the cables, but as it works 100% from floppy I've dismissed that.
It seems to me that Windows is loading corrupted datacos the CD works in dos mode.
Device manager shows nothing about CD-ROMs at all now, but under HARD DISK CONTROLLERS both the primary master and slave have yellow "!" next to them. I re-installed their drivers OK but still got "!", so I was lead to the PCI IDE CONTROLLER which I deleted and re-installed. Still got "!", so I put an MS generic bus driver in but still got "!". (yes I did re-boot after each change!)
So still stuck - I've got the latest VC running, but wonder if it is a virusthat makes Windows mis-load the bus driver every time.
Maybe I should do a format and clean install? Don't really want to cos' I've only got floppies to back up with!
by gansus67
by ian boothby
Tried all that - still no luck!
Thanks anyway!
by ian boothby
by ian boothby
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending