Question Locked

PC only boots after second try

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi. I'm trying to fix a friend's older PC - one of those no-name custom builds with a AMD
Duron processor, running at 946 Mhz. The problem is that about 90% of the time it won't
boot the first time, but it will ALWAYS boot if you turn it off and immediately turn it
back on (up until 10-12 seconds after turning it off the first time). During the first
try you get no beeps, no POST and no video, but the fans are working.

BUT on the second try it ALWAYS boots up normally and works fine until you turn it off
and back on again. I've tried just about all I can think of to remedy the problem as I
imagine with time it will get worse. Cleaned the contacts for the memory and reseated
them (2x128 mb - I know...sad). Cleaned contacts from graphic card, reseated it and
replacing it with a known working one. Connected to the onboard video controller rather than the graphic card. Tested the PSU and swapped it with a known working one. Reset the CMOS by removing the battery. Tested the hard drive, reformatted it and reinstalled OS.
I removed all peripherals (cd-rom, floppy, cards, ..etc), running it with bare ssentials. All drivers are working properly. Short of a defective motherboard or CPU, can this be caused by something else?

What's odd is that it always starts up when practically restarted immediately after first
attempt and it will run fine if used all day.

More specs:
Motherboard: Matsonic MS8308E
OS: Window XP Pro SP2
80 gb Hitachi Deskstar HDD

7 replies

by oh smeg

The Electrolytic Capacitors in it are going off and are no longer producing the correct voltages.

Col

by philldmc

Generally this is a sign the power supply is going bad. Try testing with a second power supply if you have one. Good Luck.

by rob miners

its a faulty PSU. When they get to the stage that you have to remove the power connector and plug it in again its time for a new one. On the other side of that there is no telling what damage it could be doing to the motherboard if it is producing sporadic voltage.

by grodrigz

Thanks, guys. And that was my first thought, but it turned out to be a loose jumper on the motherboard coming from the power switch. I guess heat expansion came into play here, where the first try generated some heat and the second try was enough to make contact. Now the (old) champ works like a charm. Nevertheless, appreciate it.

by rob miners

you gotta check those connections. Glad that you have it sorted out. :D

by mdbradsh

I was going to suggest checking the power switch. I had a similar experience on a friends older Gateway. I tried everything and couldn't get it to start properly. Then I noticed it seemed the problem was related to how I pushed the power switch. Changed the switch out with a new one and that was all it turned out to be. They do wear out over time!

This discussion is closed to new replies.