Discussion Locked

PC ONLY POWERS UP AFTER WAITING ABOUT 20 SECS

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

is there anyone here with a similar problem on an asus p5nd2-sli motherboard, the problem is the pc power button only works (powers up) after i wait nearly half a minute after switching the mains supply to the pc on. its only recently started happening. ive heard a possible cause could be a capacitor on the motherboard.

strange thing is if i shut the pc down and press the power button without switching the mains power off, it boots ok.

power supply is thermaltake twv(total watts viewer)-500watt showing 245watts used

4gb g-skill ram
ati x1900gt gfx
2xsamsung spinpoint in raid 0
2xmaxtor in raid 0

4 replies

by hal 9000

Quite often PS fail and don't allow enough power through to allow the M'Board and associated components to work properly.

While the Electrolytic Capacitors will take a small time to charge up they shouldn't take anything like 20 seconds.

So my first point of call would be the PS and try it with a [b]Known Good[/b] one to see if that makes any difference.

Col

by pcfanuk

First of all thanks for the reply,

Ive just measured the two most common voltages of my psu with a voltmeter and is as follows:

12v reads 12.20v
5v reads 05.15v

i will test the 3v line later...

but ive noticed something really strange on the green power LED on the motherboard (not case power LED)
when i power up the psu the mainboard LED is dim for about 20 seconds then suddenly it goes to its proper brightness, only then will the pc power up properly, even if i press the case power button it stalls untill the LED is brighter, so im not sure it could go either way here, could be the psu, or a capacitance problem of the motherboard, as ive tried every other possibility like removing ram, memory, soundcard etc.

As you said above it should not take any where near 20 seconds to charge the capacitors enough to boot the pc, and this strange problem has only just started happening about a week or so ago, until this its been really rock solid stability all round, but i have had 2 random reboots also one 5 days ago and one tonight, i put it down to windows (the reboots) until i spotted the motherboards LED activity when i plugged the pc in at the mains. When its running its all ok, but cant help wondering if it will get worse due to this.

I was wondering if you knew of which voltage of the psu i could test (if there is one) that powers the mainboard (without the system powered up) what i mean by this is if you knew what voltage of the psu was causing the power LED of the mainboard to glow dim then bright before it works.

any help whatsoever here would be very helpful, and once again thank you. Paul.

by hal 9000

Power supply is turned on and running.

Depending on the M'Board if you have a 20 or 24 Pin ATX connector you may need to check several of the 5 V DC Lines and don't forget the - 5 V DC as well as the + 5 V DC lines as well.

While it's possible to be the M'Board I've found it much more likely to be a Power Supply problem so I would honestly be looking at the correct Amperage Readings on the 5 V DC Lines rather than just the Voltage readings.

Col

by ghostbrowser

The delay my be caused by the power supply standby 5v line not able to supply all the devices on standby
I have had 1 that only failed when a optical mouse was connected
The standby 5v line is not able to supply as much power as the 5v or 3.3v
This is most likely the power supply that is the problem
Also don't forget that pci cards can use the standby 5v

This discussion is closed to new replies.