Discussion Locked

PC upgrade options?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a :
#i440BX Slot1 ATX, AGP, 128M RAM
o
# Intel Pentium II 400Mhz CPU

What are my options to reach Pentium III configuration.
Can I leave my current motherboard or get a motherboard / CPU combination.

3 replies

by thechas

I was surprissed, the 440BX chipset foes offer P3 support.

You need to check with your motherboard mfg for a list of supported CPUs.
For the fastest P3, you may need to flash the BIOS.
If you are not sure who made your MB, check out the MB ID tools at www.motherboards.org
or www.wimsbios.com
Either will provide links to the MB mfg web site once you identify who made the board.

Your CPU sources are going to be somewhat limited, as most retailers are no longer selling Slot1 CPUs.
Try either www.compgeeks.com
or www.computersurplusoutlet.com
or e-bay to find slot 1 CPUs.

Personally, I would elect to go with a new MB, and a socket 370, or even a P4 configuration.

At a FSB of 100MHz, you are only going to see marginal improvements 10- 20% if you can double the CPU speed. (The P3 itself, will give you a little bit more.)
(Unless, you run CPU intensive applications. CADD)

With a new MB, you will also get:
Faster FSB, thus all processes will run faster.
Faster IDE interface; ATA100 or 133. Either will show a significant improvement over ATA66. (if your drive supports a faster interface)
Faster memory bus speed; You will end up with either PC133, DDR, or RDRAM. All of which run much faster than your present PC100.

Chas

by chikhray

Thanks & Sorry for so long silence! I was out of my office
I have decided to buy P4.

This discussion is closed to new replies.