11 replies
by ebob
In general I figure it is rarely a waste of money to max the RAM. If these are standard SIMMs then you can always pull them and use them in a full hardware upgrade at a later point in time.
You might want to run an available system performance monitor to see if RAM is currently an issue (and it likely is). This will help justify the minor expense.
by habedd
by habedd
by danpiers
I run a computer repair facility and have worked on systems from XTs to Thunderbirds over the years. My experiences have shown me that on systems using Pentium processors of less than 200MHz, using more than 128MB of RAM is just a waste of money. I have run my own tests on several systems and found that performance improves with additional memory up to a point, then stops. For faster systems, the optimum memory is higher, of course.
I recommend that you perform your own tests before youpurchase the extra memory. With a dozen systems available to you, borrow some memory from one system and add it to another. Run a few tests, both objective and subjective to determine for yourself how much improvement is possible with the additional RAM. Of course, with memory at its current reasonable price, it's hard to discourage you. Good luck.
by habedd
by lo
May depend or your OS. Win 9x seems to like to load DLLs until all loaded or 6-10 mb memory left. I just upgraded my Win NT v4.0 from 256 to 512. The extra 256 just shows as unused memory, little taken kicking off 2-3 MS Word, MS Excel, etc. sessions. I took my Win 98 system to 128 (from 64) and still only had 6mb free afterwards. At some point, you will have more memory than DLLs depending on what sw you have on the sytem. Loading DLLs just makes the load faster.
As others have said, memory is cheap at present. Buy (or borrow) enought to test on 4 systesm or so and see what yields the best $ / performance.
by habedd
by habedd
by habedd
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending