5 replies
by mpdcsup
Boot with the cover open and listen for the drive spin-up. If you don't hear it spin, the drive's bad. If you hear it spin, try getting the BIOS to detect it. If you can't get a BIOS to detect it (try this on at least two machines -- only change the drive, no cables), it's probably bad. If you can get a BIOS to detect it, boot with a DOS floppy and run FDISK /MBR or use Ranish Partition Manager (http://www.users.intercom.com/~ranish/part/) to rebuild the Master Boot Record and the PartitionTable.
Good Luck!
by pjsplace
by csmith
Also try the Utilities Floppy from the hard drive Manufacturer.
Also check the Power Supply.
Last week a PC came in, and it would not boot, and it had these same errors, plus sometimes it would say the ROM Checksum was bad. The power supply voltages were out of tolerance. (Too low.)
A new Power Supply got rid of the symptoms.
Regards, Chris
by pjsplace
by pjsplace
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending