Question Locked

Pc Won't boot at all after reconnecting old SATA (!!!??)

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

This is lengthy- i apologise, but in all my years i've never seen this happen before, and it's critical i find a solution

over the time since i built my I have accumulated 4 HDD,
2X IDE (work fine)
and 2X SATA > one is an older 250gb sata1
> the second (newest) is a 320gb sata2 (but jumpered to work at 150)

have just been using a different os on the new 320 sata2 for a while now (forgot to order some cables)

, i disconnected all my old hdd's (just the cables and left them in the case)

BUT i just tried to connect both sata's up at the same time, and my pc wouldn't start at all (just got the green power light, no fan noise whatsoever)

this lead me to initially believe that it was a PSU issue, but have tired various combinations of all 4 hdd's and the only time it will start is when my older 250 sata is not connected.

before trying both sata's at the same time this drive worked fine, and my pc would turn on just fine, but now after trying the two together , when this drive is connected pc won't start at all.

please any suggestions for a solution, or even a stab at what the issue is would be a great help

thanks

5 replies

by 79eric

will pc boot when ONLY the 250gb is plugged up?
if so, check the jumper settings.

if pc will not boot with only 250gb connected, then the hdd is bad.

or else, try the hdd on another computer. if it works fine there, then it's your MOBO.

by older mycroft

I doubt if the OP is still waiting for an answer - not after 2 years and 4 months. ;)

by ---tk---

You don't need to use the jumper to force it back to sata1... The Mombo will, by default only pull at the speed it can handle... put the jumper back to where it was and try it.

This discussion is closed to new replies.