Discussion Locked

PC won't boot with usb device connected

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have just purchased a Nisis USB Graphics Tablet. With the device plugged in my PC will not start. If I start my PC and then plug the device in everything is Hunky Dory. I am running Windows 98 on a 400mhz Pentium 2 Gateway 2000 Tower PC. I Have looked on MS Knowledge Base and Gateway US site but can't find an answer. Could somebody please help me with this? I want to use my new kit!

6 replies

by keithg.milner

It powers up, runs the fan, displays the Display Adaptor details and then the Gateway 2000 logo as normal. It freezes at this point. I think the PC would then go on to detect my hardware and start Windows if it didn't freeze.

by timthetoolman

Hi again,

Well I checked out Nisis' info on your tablet and the link I used to get there from a search engine was broken. So whilst the site is pretty and all, the lack of rigour (at least for the IT guys) isn't great. I wonder if that extends into their company?

I mentioned this because its possible that you have a faulty or maybe even poorly designed product...

Anyway... the things for you to do are these...

1. Check the tablet in another PC. That will tell you whether its your PCat fault or something to do with the tablet itself.

2. If its your PC, then upgrade the BIOS. You'll find this downloadable from the motherboards' manufacturers website.

3. If its something to do with the tablet then...

4. Disable USB in your BIOS and try booting. This will tell you whether its a hardware problem or a software one when the device is detected and the drivers are loaded or the device is initialised.

5. If its a possible hardware problem then try swapping it (hopefullyunder warrenty)

6. If its software, then check for and install the latest drivers available on Nisis' website.

Hope that helps,
Cheers,
Tim.

by thechas

If Tim's suggestions don't take care of things, I have a couple more ideas.

1. Disable USB legacy device support in BIOS settings.
It is possible that if Legacy USB support is enabled that the BIOS is unable to get past the fact that the Tabletis an input device, but not a kybd or mouse.

2. Place a powered USB hub between the PC and the Tablet.
The tablet may be drawing more power than your USB port has available at boot.
It works after boot because there are fewer demands on the power supplies after the system has completed the boot process.

Chas

by keithg.milner

There have been some further developments in this little saga. Firstly I have received a replacement Graphics Tablet from Nisis. I am still getting the same problem, so I guess it is not the tablet. I have got the latest BIOS for my PC, the latest USB drivers and a powered USB Hub and still get the same problem. I am also getting the same problem with another USB device a Fuji Digital Camera. I think I may have a problem with Windows 98. Has anybody else had this problem and does anybody know of a fix or any thing I could try? Thank you.

This discussion is closed to new replies.