8 replies
by far2east Accepted solution
by nexs Accepted solution
Perhaps it is an issue with the power at your house. is it plugged directly into an outlet in the wall or a powerboard?
If it's in a powerboard, then maybe it has a surge protector and you need to unplug it from the wall and press the powersurge button on the powerboard. Also, have you checked the switch board outside your home for the circuit breakers?
those are the only other things i can think of!
let me know how you go
by far2east Accepted solution
by mark.giblin Accepted solution
If your 100% sure its not the UPS or the built in surge protection... You then need to be looking at your PSU.
What is the "Wattage" rating of the PSU in the machine? and what is the power requirements of your new hardware?
I recently went to a job for a PC that smelt like it was burning something.
Turned out that the person who claimed to have built the machine to "Professional" standards had put a 200 Watt PSU in the machine and the PSU was cooking itself from the demands from the board. Technically the unit shouldn't have powered up but it did, leading me to believe that the PSU was very old and possibly faulty.
I put a 550 Watt PSU in the case and the problem was solved along with the sporadic rebooting.
The important factor here is the wattage output of the PSU, if it is not high enough, you can have problems and if you have upgraded the machine you say you tried 2 power supplies already but did you check what the capability of the PSU's were?
by far2east Accepted solution
by ismail.magued Accepted solution
hello again
First of all
check the electrical socket and check that you have at least a 32AMP fuse in your fuse box. in the event that everything is fine
But I repeat make doubly sure that there is no faulty fuse no faulty wiring from your nearest electrical engineer.
If after the above sequential check every thing is fine you go
you check the following
check the motherboard out, make sure it wasnt damaged in any way.
because it seems something in your motherboard may have taken on alot of current
and may be damaged.
ask to have the chipset looked at as well.
do the above and tell me what happens
and well we can take it from there.
Please keep me updated
by ismail.magued Accepted solution
Here is what you do
first of all
did you check your supply?
check your power supply than get back to me
if not
if that does not solve the problem
than get back to me
ill be checking the forum here daily for any updates.
so please stay in touch.
by far2east Accepted solution
That was the first thing I replaced. I tried 2 brand new ones. the details are in the previous response.
Thanks for the response.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending