Discussion Locked

PCI IDE Card

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have installed a PCI IDE card in my computer and I have attached to it a DVD Rom drive and a Seagate 80gb HDD. I would like to know how I can get Windows to recognise there is another drive. I currently have 2 hard drives connected to the main IDE channel on the motherboard.

I am wanting to use the other driver for storage purposes but as I mentioned above, I need to be able to see it in Windows.

I run Windows 2000 Pro with SP3, AMD 2500+ and 1gb DDR ram.

9 replies

by sgt_shultz

the bios on the add in ide card should be taking care of that for you...exactly what model pci ide card have you put in? does it have jumpers on it?

by daz'n'ash

Well, I figure out the problem. The HDD had been formatted to NTFS and Windows would not recognise it.

by daz'n'ash

Xsonic Unltra ATA IDE Raid Controller Card. No jumpers on it.

The HDD Is set as master, the DVD Rom as slave if that helps.

by dmiles

With the PCI IDE you have to install the driver for the card,has this been done?

This may be the cause for drives not showing up in Windows

by thechas

You should see a splash screen just after the motherboard POST that will display the drive detection for the PCI IDE card.

It is possible that you need to enter the IDE card's setup program to enable the drives.

As dmiles stated, you need to install the driver for the IDE card before Windows will recognize it.

Once Windows recognizes the card, you will need to enter Computer Management and partition the drive before Windows will allow you to access it from Windows Explorer or applications.

1 other thought, some of these PCI controller cards do NOT work with optical drives (CD - DVD).
The DVD drive may be causing the controller to lock up.
At a minimum, I would install the hard drive and DVD drive on different IDE channels (cables).

Note: if you split the drives, make sure to set the hard drive to single drive.

Chas

by daz'n'ash

Card was not the problem. Windows recognised the card with no problems. I have had my DVD Rom hooked up to the Raid and working previously. Thanks for trying anyway.

by daz'n'ash

Hi Chas, ncie to see your comment. The card is working just fine as is the DVD Rom attached to it. There is an option at boot up to press F3 to enter Raid configuration. I have tried this and will attempt to try my idea of why this problem exists. I think I have found out why it isn't showing in Windows, but keep trying. I will award the points to whomever has the correct answer.

This discussion is closed to new replies.