Discussion Locked

PCI modem problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

This is something I am going crazy about.

I have downloaded an MS-DOS internet browser named arachne (see http://browser.arachne.cz for details) and when I tried it with a PCI modem, it said it could not connect. Now I switched to an ISA modem (slower baud rate) and it could connect. However in Windows, both modems are able to connect. The PCI modem uses drivers in Windows and the ISA one doesnt. I have researched and realized that the PCI modem does NOT have a UART chip and the ISA modem does. This UART chip is supposed to let MS-DOS recognize that a modem is installed on COMx, IRQx. I know there are video game emulators but I dont know of any UART emulators. and another thing, I checked the properties sheet and the check box for "Enable Dos Support" is grayed out, however all the files are installed correctly.

So if your solution allows me to use my PCI modem in dos, you get the points.

Computer Specs:
PCI modem: Diamond Multimedia SUP2260 56K.
Processor: Pentium 200
OS:Windows 98
RAM: 32MB
Free Disk Space: ~1GB
Total Disk Space: ~1.6GB
Resolution: 640*480

5 replies

by stillatit

DOS does not always recognize plug and play devices. It is possible that the device has settled somewhere other than the standard IRQ's and locations for com1, com2, com3 or com4. If this is the case, the program probably cannot find the modem.

The uart may or may not be the real issue.

If the modem has a way to be forced to com1, try that.

Silly question -- Have you queried the modem manufacturer's site?

Good luck.

by mike (from canada)

actually, I have managed to force it to COM1 and that didnt work. I also downloaded an IRQ redirecting software and that doesnt work either. and yes, I tried the modem manufacturers site :)

by mike (from canada)

Regarding answer #1: Yes I have tried contacting the manufacturers site. I have done what they suggested and they did NOT help at all. Yes, I am able to assign COM1 to the modem in WIndows 98 but MS-DOS cant recognize the modem at all no matter if it is in windows 98 or DOS.

by grbeckmeyer

Sounds like you have a Winmodem, or software modem. This will NOT work under DOS. I have heard of Linux drivers for some Winmodems, but I have never heard of any drivers to get one of these working under DOS. You simply need a hardware modem, with the Uart chip, to be able to use it with a DOS program.

This discussion is closed to new replies.