Discussion Locked

PCI or AGP

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am in the process of looking for a new graphics card, but I can't figure a out if I need to get a PCI or an AGP. I can't figure out what kind of card I have at the moment, except that it is a NVIDIA TNT2. Anybody have any tips to figure out whatI have, or what I need?

13 replies

by maxwell edison

The NVIDIA TNT2 coulb be either a PCI or AGP. If it's inserted into the white expansion slot, then it's a PCI card. If it's pluged into the brown slot, it's an AGP.

Link to photo of AGP:

http://tinyurl.com/68ey

Link to photo of PCI:

http://tinyurl.com/68ez

AGP video slots allow the graphics to run faster - great for video and graphics extensive applications.

by jose_12650

Your choice is limited by your motherboard. See first if you have an AGP port or only PCI bus slot. The AGP slot is normally colored brown and is a little bit shorter than the PCI slot which is colored white.

by lwd86

AGP is faster but there are different flavors of it, ie. 2x, 4x etc. You need to get your book on your motherboard. It will tell you what your system can support. The card in your system is probably the style you need. You need buy a card with the same edge connector and more memory.

by thechas

You can look in device manager to see what type of slot your present video card is in.

If you have an AGP card, there should be a listing for an AGP port.

You can also download and run Belarc Adviser

www.belarc.com

It will give you a fairly detailed report on your system configuration.

Which-ever way you go (AGP or PCI) I recommend that you install the latest drivers for the chip-set on your motherboard before installing the new card.

Also, just before you shut down the PC to swap cards, go to device manager, and remove your old video card.

Check Add/Remove programs for any utilities related to the card, and remove them also.

After you shut the PC down, be sure to shut off the power supply, or unplug the PC to assure that ALL power is off.

Chas

by djent

If you use an AGP card be carful to get the correct card ie: PCI 1=3.3volt and PCI 2=1.5 volt. A PCI 1 card may damage a MB designed for PCI 2, I mean fried MB. Check MB specs and AGP slot config, they are different.

This discussion is closed to new replies.