Question Locked

PCI TO MICRO CHANNEL BRIDGE

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I HAD TAKEN SOME PHOTOGRAPHS ON A MOTOROLA
MOBILE PHONE. THIS MOBILE HAS A EXTENDABLE
MEMORY CARD. {SD MICRO CARD } THE CARD WAS IDENTIFIED THOUGH THE CARD READER THEN I DOWNLOADED SOME VIDEO CLIP [3 GP FILE } MENT FOR THE NOKIA MOBILE. THE VIDEO CLIPS WERE SUCCESSFULY LOAD.NOW THE CAR IS NOT IDENTIFIED IN THE MOTOROLA MOBIL PHONE NOR IT CAN BE IDENTIFIED IN THE CARD READER. I AM GTTING THE MESSAGE NEW HARDWARE INSTAALLED AND REQUIRES PCI TO MICRO CHANNEL BRIDGE DRIVER. THE REQUISITE SITE FOR THE SAME IS WITH MOTOROLA SOFTWARE,BUT THE PAGE FOR DOWNLOADING THIS SOFTWARE IS NOT AVAILABLE. WHAT COULD BE THE REASON ? AND OTHER SOLUTION ?
SUHAS PARANJAPE

3 replies

by older mycroft

Did you use the Safe Removal method just as you would do with a USB Thumb Drive?

If you didn't and just whipped the SD Card out of the reader, there is every chance you have corrupted the format within the card memory.

I'm slightly confused as to where the Nokia fits in? I thought you had only an SD Card and a Motorola.

This discussion is closed to new replies.